
Tungsten™ E2 Handheld 77
CHAPTER 5 Moving Info Between Your Handheld and Your Computer
Synchronizing over a network
WINDOWS ONLY
You can synchronize over your company’s network in one of three ways:
• By using your handheld’s built-in Bluetooth wireless technology to make a wireless connection
to a network
• By dialing in to a network
• By connecting to any computer on the network using a cable or your handheld’s IR port.
Use network synchronization if you are not close enough to your computer to synchronize directly
using a cable or the IR port.
The first time you synchronize, you must use the cable or infrared
communication. After that, you can synchronize over a network.
Synchronizing by dialing in to a network
0
1 Prepare your computer for network synchronization:
a. Turn on your computer.
b. Click the HotSync Manager icon in the taskbar in the lower-right corner of
your screen, and then select Network.
c. Click the HotSync Manager icon again, and then select Setup.
Continued
Before You Begin
The following setup must
be done before you can
synchronize over a
network:
• Your computer must
have TCP/IP installed.
•Your company’s
network system and its
remote access server
must support TCP/IP.
• You must have a
remote access account.
Check with your system
administrator for
assistance.
To synchronize by dialing
in to a network, you must
also have a mobile phone
(sold separately) that you
can use as a modem to
dial in to the network, or
an attachable modem
accessory (sold
separately).
IMPORTANT
[
! ]
Comentarios a estos manuales